Let’s check our aerogarden tomato guide. The idea of growing a fresh crop of tomatoes outside of their natural environment used to mean that you had to install a greenhouse to cultivate the tomatoes. The market is booming for clever garden hydroponic systems this is no longer the case. We’ll go over everything you must know about cultivating and harvesting AeroGarden tomatoes.
Also, it is possible to harvest incredible cherry tomatoes which are fresher and tastier than supermarket tomatoes. Naturally, it’s not going to be any fresher than picking the tomato from hydroponic plants on your counter and then onto your table.
In the article, I will go over everything you need to learn about growing and harvesting AeroGarden Tomatoes efficiently.
- What Kinds Of Tomatoes Can You Cultivate Within Your Aerogarden?
- Steps to Grow Tomatoes in the Aerogarden
- Step 1: Make Your Aerogarden
- Step 2: Light Configuration
- Step 3: Plant Tour Tomato Seeds
- Step 4: Don’t Ignore Liquid Nutrients
- Step 5: Trim Your Tomato Plant
- Step 6: Convert Your Plant to Pollination
- Step 7: Pruning
- Step 8: The 8th Step in Pruning
- Step 9: Supporting the Overloaded Branches
- Aerogarden Tomato Plant – Growth Phases
- Phase 1. Germination
- Phase 2. Mid-Growth
- Phase 3. Mature Plant
- Phase 4. Mature Plant and Harvest
- What You’ll Need Cultivate Tomatoes In Your Aerogarden
- Harvesting AeroGarden Tomatoes
- AeroGarden Tomato Tips and Tricks
- Aerogarden Tomato Guide Wrap up
- Do tomatoes grow well in AeroGarden?
- How long do tomatoes take in AeroGarden?
- Which AeroGarden is best for tomatoes?
What Kinds Of Tomatoes Can You Cultivate Within Your Aerogarden?
There’s no need to admit that I failed badly in my attempt to cultivate tomatoes for the first attempt in an aerogarden. The reason why I did not succeed was the decision to grow massive tomatoes. You could do it however it will require an advanced cultivation system. It was a very basic model at the time.
Additionally, as tomatoes expand they become too heavy. If you plant them outdoors there is lots of room to offer some form of support. The area in the aerogarden isn’t enough to place a stick in order to secure the plant.
This is the reason I suggest cultivating a cherry tomato first. These garden plants are tiny, so they can be grown inside the form of an Aerogarden design with a few basic characteristics.
Steps to Grow Tomatoes in the Aerogarden
Step 1: Make Your Aerogarden
This process doesn’t require the most effort. Similar to before planting another kind of seed, it is recommended to clean and sanitize your AeroGarden prior to planting. The only exception is when you’re using the brand-new AeroGarden that has never previously been used. The complete procedure for cleaning, sterilizing, and dissolving the AeroGarden is here. Once your system is completely clean, you can add water.
Step 2: Light Configuration
It is important that you place the light as close to your system, and to the lowest achievable level. Tomatoes don’t require any bright lighting, but they require at least 16 hours of lighting per day. Therefore, set your timer to ensure that will keep the lights switched off for 8 hours per day. Make sure you move your light hood in line with the development of your tomato plant. There should be about one to two inches between the light and the very first leaf of tomato.
Step 3: Plant Tour Tomato Seeds
They require lots of space. If you plant them, ensure that you leave some space. Don’t make use of the seed pod slots between or plant something else that needs minimum space, for example, basil. For outdoor gardening, tomatoes do best in greenhouses, so be sure you put their domes in.
Step 4: Don’t Ignore Liquid Nutrients
It is important to note that the amount you require will be different, depending on the number of tomato plants you’ll grow. Follow the directions on the packaging and adhere to the instructions. If you’ve taken the decision to use tablets that contain nutrients in place of liquid, make use of one tablet for 3 tomato plants.
Tablets and liquids should last approximately two weeks unless the nutrient reminder has been turned off. Make sure to reset the device each when you add nutrients so that the system can be aware that it has been replenished.
Step 5: Trim Your Tomato Plant
As your tomatoes begin to develop be sure to take off the domes. When they are about 2 inches in height, you need to cut off any weak shoots that are growing tomatoes off. Be cautious not to harm it, and when you have done it correctly you should end up with a strong plant.
Step 6: Convert Your Plant to Pollination
If your plant starts to bloom and starts to bloom, it’s time to get pollinated. Because your indoor aerogarden isn’t a natural one you won’t have the bees that can do the job for you. However, there is a method to create it yourself. It is as simple as shaking the plant gently and you can blow over it with a gentle blow. Keep in mind that it doesn’t require any time to get started.
Step 7: Pruning
Pruning the right way is approximately four weeks following the planting within your system. Pruning can be done in two stages. The first is taking off the stem just a little above the initial five branches at the lower part of the. This can be done with regular scissors, just be sure they’re clear prior to cutting. You may skip this step when your tomato already has flower blooms.
Step 8: The 8th Step in Pruning
The branches that grow outside the reach of the light must be cut off. If the light hood is set to the most extreme setting, you need to cut off any branches growing towards the light source in order to leave at the very least two inches of space between the upper branch and the lights.
The stems and branches which are growing beyond the reach of light, or blocking light from reaching your plant, will cause harm to it. If they are not in the light’s reach are eating up the energy and not making any tomatoes. The branches that are growing into sunlight will block light and stop the other branches from gaining anything from it.
Step 9: Supporting the Overloaded Branches
The tomatoes are heavy and often too heavy for their branches. This is the reason you need to tie a string (the ideal is to use a string made from organic materials) and then tie the heavy tree to something. It could include the arm of your lamp or something else that is close to it. If the branches fall off when the tomatoes are green, they’ll never be ripe and red.
Aerogarden Tomato Plant – Growth Phases
Now, you are aware of the steps to follow when cultivating tomatoes in an aerogarden. The timeline for growth will help you to know what to do and when to maintain the tomato plants. You’ll also be aware of the size of your plants that will be growing tomatoes each week.
Let’s look into the different growth stages in an aerogarden plant from week to week and the care they require from time moment.
Phase 1. Germination
First Week: Getting started with the tomato plantation may be a little difficult at the beginning of the week. You will need to establish the ideal environment for growth with the best conditions for tomatoes. If you have had herb plants in the aerogarden earlier tomatoes require a lot more attention than herbs. Note these aspects:
- The water’s temperature should be 75 degrees.
- Tomato thrives best at room temperature.
- Give a firm shake to the container of nutrients prior to placing it in the aerogarden. Use only the recommended dosage in accordance with the instructions.
All of the above requirements are crucial to your achievement in the mission aerogarden tomato!
Second Week: By the end of this week, you’ll notice that there’s a young stem is beginning to grow with the leaves emerging from through the hole. This is the best time to get rid of the domes made of plastic.
There is a good chance that you will get at least two plants in each hole. Be sure to watch these plants carefully, and then work on thinning. You must cut off the weaker sprouts from the bottom of the plant’s stem.
Week 3: There isn’t much work to be done this week. However, you must monitor the water level and the nutrients indicator. Supply the water (room temperatures) and nutrients as needed.
Phase 2. Mid-Growth
Week 4: Even though this entire week there’s little to be done. If you’ve changed the water or added nutrients in the week before then this is your time to rest.
Week 5: The time to prune tomato plants. Leave five branches at the lower part of the stem. Be careful not to cut off the second and third leaves (it could impact the plant’s growth).
Look for the Y-shaped growth at the point at which the flower buds begin to grow. With sharp scissors, trim the area close to the point where the branches have split.
Pruning your tomato plants at this point, and following the correct procedures will help to ensure that you harvest two tomatoes.
Week 6 is you aren’t doing any work this week, except for pruning. If the nutrient and water indicator isn’t showing an alert of low supply continue to monitor the plant for growth that isn’t correct.
It is necessary to raise the lights if leaves or stems are in contact with the panel. If the leaves are to the point of being too big for the lights, remove them. It is necessary to cut off the branches and tall leaves. This will let more light and better growth of the plant.
Phase 3. Mature Plant
Week 7: Flowers begin blooming in the weeks of 5 – 7. There are small yellow-colored tomato flowers on all plants. If you do not carry out the pollination process then they’ll fall off. The result…you will not get any fruit. I’m talking about luscious tomatoes.
When you let them fall off, you can perform the pollination by using the brush or employing a soft-blowing fan.
Notice: If you have too many blooms, you will need to get rid of some so that you have enough room for the fruit to grow and mature.
Week 8: When you pollinate prior to the week before the tiny fruits will appear within the blooms. The plants which are not producing fruit need more pollination. Repeat the same steps as you did in the previous week. Certain plants need longer to finish producing fruit.
Some leaves may change from a brownish-yellow color because of drying out. This happens to every plant. Cut them off using garden scissors.
Phase 4. Mature Plant and Harvest
Week 9-12: Aha! Your hard work is paying off. Now is the time to harvest those sweet fresh tomatoes. Make sure not to put too much pressure when your harvest the tomatoes. As we mentioned before in the article, if the branches fall off at random, you won’t have tomatoes that are ripe for a while.
However, you must continue to pollinate the flowering plants as they grow to ensure the next harvest.
What You’ll Need Cultivate Tomatoes In Your Aerogarden
While your plants require minimal attention, however, it is essential to be cautious before you begin.
This is why it is a good idea to gather everything you need prior to beginning the planting process. The following things, so make sure you have these items in your bag:
Harvesting AeroGarden Tomatoes
Your tomato plants are expected to harvest around three months later. Pick tomatoes when you’re ready to consume them.
Here are some helpful suggestions to help you take advantage of your tomatoes to be the most delicious.
- To determine if the ripe tomatoes you can give the tomato a gentle squeeze. If it’s mature, it will appear firm and have a little bit of “give” when you squeeze.
- Keeping a portion on the stem as well as a tomato leaf in place when you pick your tomato is a good idea even if you don’t plan to eat your tomatoes right immediately. Your tomato can continue to draw moisture and nutrients off the stem for two days.
- The ideal time to harvest tomatoes is right before you eat them to ensure that you are enjoying them fresh and with the sun’s ripened taste.
- Avoid refrigerating your fresh tomatoes can ruin the benefit of all the work you’ve put into them. Refrigeration can ruin the fresh taste and makes the flesh into a pulp. If the fruit is ripe then go ahead and pick fresh fruits to keep in the fridge instead of letting it time to ripen.
AeroGarden Tomato Tips and Tricks
AeroGarden helps make cultivating tomatoes indoors simple.
Here are some suggestions to ensure success and that this simple procedure yields the most effective outcomes.
Aerogarden Tomato Guide Wrap up
I hope that you have enjoyed reading this article. You should be aware of what you have to do to cultivate tomatoes in your aerogarden.
Tomato plants thrive long within the garden. The fresh tomato from this plant is at most one year following the abundant tomato harvests.
This clearly shows how vital it becomes to cleanse the aerogarden even if the plants are already present. If you do not change the amount of water in your system or cleanse it regularly the system is more likely to be a breeding ground for harmful fungi and algae. They can cause damage to your plants.
Be sure to take good care of the plants and clean your system regularly, and stay prompt in providing food and water. All of these will ensure your success in your mission to cultivate tomatoes.
Do tomatoes grow well in AeroGarden?
Cherry tomatoes do best when they’re in the AeroGarden because they’re small. You can pick from Heirloom Cherry Tomatoes (6 pods or 9 pods), Mini Cherry Tomatoes (3 pods 6 pods, nine pods), Golden Harvest Cherry Tomatoes (6 pods or 9 pods), and Mega Cherry Tomatoes (for Tall AeroGarden models).
How long do tomatoes take in AeroGarden?
It’s a great option for those living in apartments or those who don’t have an outdoor space suitable for an established soil garden. The process of growing tomatoes in AeroGarden is a breeze. AeroGarden generally requires between 9 and 12 weeks.
Which AeroGarden is best for tomatoes?
The most effective AeroGarden to grow tomatoes is called the Farm24XL because it comes with the biggest space for growth at 36 inches. If you’re in a tight space and want smaller units, it is recommended to use the countertop Bounty Elite as your best choice for growing tomatoes.